null

A guide to applying ozone to both feet

Have you ever suffered from Athlete’s feet or nail fungus? This is a much more common problem than most people like to admit and it usually affects both feet at the same time. Fortunately, if you believe in ozone, Promolife has a simple solution that can equally apply ozone gas to both feet at the same time (can also be used with hands).

When applying ozone gas to the feet a self-contained system with a tight seal is recommended, which is why we recommend the Promolife Limb Bag with Built-In Seal for the Arms. That’s right, the arm bag will securely seal around your feet.

I will now go step by step on what is needed and how to treat both feet at the same time. Before starting make sure you have the following items.

items

1.


Start with your two limb bags.

Use the limb bag splitter to connect both bags. The limb bag tubing comes with male luer lock connectors and the splitter has two female luer lock connectors that will allow you to connect.

splitter

2.


Once both bags are attached to the splitter, slide the bags halfway up the foot. As you can see the bags are around my feet but under the ankle. I have found this creates a much better seal that traps all of the ozone gas. The key is to keep the ozone in the bag until you’re done with your session.

bags

3.


Once the bags are properly secured around your ankles, you will want to remove as much excess air as possible. To do this, simply roll and press the bags while allowing air to escape through the built-in seal.

(Tip: Slide a finger under the seal to let air escape)

bag

4.


Now we are ready to add ozone. Take the tube coming off of your ozone generator and simply connect it to the base of the Y Splitter. The Y Splitter base has a barbed connector that will allow you to slide your silicone tubing over the fitting. Make sure the clamp on each limb bag tubing is in the unclamped position.

clamp

5.


Now you are ready to turn on your ozone and oxygen. I personally recommend an oxygen flow rate of 1/4 LPM and an ozone setting that will give you between 25 and 40 gamma. You will want the ozone gas to flow for roughly five minutes. After that you should notice the bags are slightly inflated.

6.


You can now turn off your ozone and oxygen. Once both are turned off, clamp the tubing on each bag and then disconnect from the tubing from the splitter.

This will give you feet more mobility and prevent any of the ozone from escaping into the room.

7.


Leave the bags on your feet for an additional five minutes to let the ozone gas absorb.

When you remove the bags a good amount of the ozone will have absorbed or dissipated, making the amount of ozone left to enter the room harmless.

 

You have successfully treated each of your feet with ozone gas the fastest way possible. For an additional boost in fighting athlete’s feet or nail fungus make sure to check out PurO3 Toe and Nail Support. PurO3 Toe and Nail support uses ozonated oils combined with strong penetration agents such as DMSO and Turpentine.