This glass bubbler is great for breathing ozonides through oil. The bubbler and straw are made of glass while the tubing is made of silicone. Many people use it to breath ozonides after ozone bubbles through oil. This changes the chemical structure of ozone so it is breathable and non-irritating.
The 200ml Promolife Ozonide Oil Bubbler is specifically designed for use with ozone therapy.
Simply fill the bubbler with the desired amount of oil, attach the tubing coming from your ozone generator to the straw that goes all the way into the oil, and attach your other tubing to the other straw.
What does it come with?
Each oil bubbler comes with a free nasal cannula and an instruction sheet on how to set up the glassware. It comes with tubing and adapters already installed, with a stand that will keep the bubbler from tipping over.
Other Uses
If you want to ozonate small amounts of oil, we highly recommend adding on an ozone destruct system.
Video Transcript
Hey everyone, my name is Colton and today I'll be setting up the ozonide breathing oil bubbler.
Before we begin, you will need your oxygen source and ozone generator ready to continue with the setup. If you still need to set up your oxygen source or ozone generator, please watch our videos on how to set those up first.
For this setup, you'll need the 5ft section of silicone tubing and check valve connector set that was included with your generator and a breathing oil bubbler with the included nasal cannula. For this setup, I'll be using the 200ml oil bubbler, but the setup will be the same for any Ozonide breathing oil bubbler glassware.
The Ozonide breathing oil bubbler is used as a breathing treatment for respiratory and sinus issues. To begin, we'll place the stem into the flask. And then we'll take the 5ft segment of silicone tubing with check valve connector set that's included with the generator and connect this end that has a fitting to the ozone out port of the generator. We'll then take the other end of this tube and attach it to the top segment of tubing on the stem here.
We can then attach the nasal canula to the other fitting coming off the oil bubbler stem.
Now that we have everything connected, we can turn on the oxygen source and set the flow rate. Most will use the flow rate of 1/4 L a minute when using the oil. At this point, you can put on the nasal canula and power on your generator to whichever dial setting you would like to use. Most will breathe the ozonides coming out of the oil bubbler for 15 minutes one or two times a day. Once that time is elapsed, you can power off your ozone generator and turn off your oxygen source. You'll also want to disconnect the tubing on the ozone out port of the ozone generator to prevent the back flow of oil into the ozone generator.
Thanks for watching. Check out our other YouTube videos for more information and be sure to follow us on social media. Make sure to hit that like and subscribe button and hit that notification bell for future videos.
Setup Guides
All of Promolife's Ozone Glassware is made with Class A Laboratory Grade Borosilicate Glass.
