The IQ 40 is the  “Intelligent” advantage over any other heat regenerative air dryer on the market today.

This Dryer is fully automatic and self-regenerating.  This Dryer is a Vacuum air dryer. The Ozone Generator fed by this dryer requires a vacuum source. Airflow should be regulated by an air flow meter to the ozonator specifications.

You will always have dry air flowing into your ozone generator. This unit is ideal for swimming pools that operate 24 hours per day.
 

Specifications

• AIR FLOW:  0.5-40 Cubic Feet Per Hour
• WATTAGE:   50 VA Average; 90 VA Maximum
• DEW POINT:   -50 to –60 Degrees
• PHYSICAL DIMENSIONS:   13” High X 10” Wide X 3.5” Deep - 15 lbs
• VOLTAGE:   115 VAC, 60 Hz (Standard) 
• CHASSIS:   Baked Silver Enamel Over Aluminum
• One year warranty

Dryer is Suitable for Indoor or Dry Locations Only. If Installed Outdoors, Dryer Must be Protected From the Weather.  If unit is to be installed outdoors, an open ended cover should be installed to prevent direct exposure to the elements. This cover should extend at least SIX inches in all directions, and be located at least SIX inches above the TOP of the dryer to allow unrestricted convection of air through the unit.

Air Dryer should be installed in a vertical position, with the AIR outlet (1/4” npt female fitting) on the RIGHT side. The perforated sides should be TOP and BOTTOM, to allow air convection, and should not be blocked or covered.   Dryer should be plugged into an outlet for continuous duty. It is not  recommended to power up the unit intermittently even at times when there is no air flow from the venturi.
 

Installation

• The timing circuit on the printed circuit board is designed to operate properly even when a power loss occurs! This means that the I.Q. 40 Dryer remembers which drying bed was in operation when power ceased. This is very important, as you do not want moisture entering your ozone generator. Typical air dryers do not have this capability and can deliver air from a saturated dryer bed causing problems with your ozone generator.  
• YOUR I.Q. 40 DRYER SHOULD BE IN USE AT ALL TIMES, WHEN OPERATING IN CONJUNCTION WITH AN OZONE GENERATOR!  
• This input relates to initial installation and startup.  During transit from the factory to destination, the drying agent in the chambers absorbs an incredible amount of moisture.  Upon initial turn-on of the system, this large amount of moisture is immediately being pulled into the ozone generator chambers.  This in turn could cause a decrease in ozone output and possibly a blown line fuse.
• IN ORDER TO AVOID THIS PROBLEM, PLEASE ALLOW THE DRYER A THREE (3) HOUR WARMUP PERIOD PRIOR TO CONNECTING THE FLEXIBLE HOSE TO THE OZONE GENERATOR INPUT
• These models provide a cost effective alternative to “Oxygen Concentrators” for numerous applications. This series is suitable for indoor or dry locations only. If installed outdoors, the units must be protected from the elements.